Door Panel Removal: (See image for locations)
Step 1: Use a flat head screwdriver and remove the plug at the bottom of
the "grip" (what you use to close the door from the inside). Remove the Phillips screw. Gently pry the back of the section
up. When the grip pocket has cleared the panel, pull backward and the whole assembly should pull out. Disconnect the connectors
for the power windows and door locks and put the piece to the side.
Step 2: Gently pry the cover off the panel. Remove the phillips
screw underneath.
Step 3: Gently pry off the door handle trim. Start at the back, then using a small flat-head screwdriver, work
the piece off by wedging the screwdriver between the trim and the plastic behind the handle to release the clips.
Step 4: The outside edge of the
door panel is held to door with plastic clips. Using a panel popper or flat head screwdriver, gently pry the panel away from the
bottom of the door. On my car, there was a section below the map pocket that I could put my fingers in and help pull. Once you
have the first clip loose, you can run your hand along the edge to disengage the remaining clips. Once disengaged, pull the panel
out from the bottom and push upward to disengage the trim at the top. You can either leave the door panel hanging from the wires
running to the courtesy light/fuel filler/trunk or you can disconnect them. It's your call.
| 
